EggGen3

From SubeNews
Revision as of 20:31, 8 August 2012 by Deej (talk | contribs)
Jump to navigationJump to search

Eggenfellner Gen3 Gearbox

Manufacturer's Listed Specs

Gen3 Howto Guides

    If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.
   (Note: Add the following sentence at the end of step 12 in the Gearbox Alignment Instructions:
   "Tighten all bell housing bolts to approx. 250 lb.-in. then recheck alignment."
   This step will insure that everything stays put while you take your time applying Loctite and installing 
   bolts for the last time.)

FAQs (Frequently Asked Questions)