EggGen3: Difference between revisions

From SubeNews
Jump to navigationJump to search
Line 22: Line 22:
* [https://wiki.subenews.com/files/Gen3-Gearbox/Gen3-Gearbox-Video.wmv Gen3 Gearbox Video]
* [https://wiki.subenews.com/files/Gen3-Gearbox/Gen3-Gearbox-Video.wmv Gen3 Gearbox Video]
* [[EggGen3:2009H6|Pictures of the 2009 H6 gearbox mounting (should be the same for 2007 and later)]]
* [[EggGen3:2009H6|Pictures of the 2009 H6 gearbox mounting (should be the same for 2007 and later)]]
* [https://wiki.subenews.com/wiki/images/8/88/EggPSRU3v4-diagram.pdf Visio Diagram of Bearings and Seals for Egg PSRU 3v4] ([https://wiki.subenews.com/wiki/images/0/0a/EggPSRU3v4-original-sketch.png original sketch])
* [https://wiki.subenews.com/wiki/images/8/88/EggPSRU3v4-diagram.pdf Visio Diagram of Bearings and Seals for Egg PSRU 3v4] ([https://wiki.subenews.com/wiki/images/0/0a/EggPSRU3v4-original-sketch.png original sketch])([[File:EggPSRU3v4-diagram.vsd]])


== FAQs (Frequently Asked Questions) ==
== FAQs (Frequently Asked Questions) ==

Revision as of 19:33, 11 December 2012

Eggenfellner Gen3 Gearbox

Manufacturer's Listed Specs

Gen3 Howto Guides

   (Note: Add the following sentence at the end of step 12 in the Gearbox Alignment Instructions:
   "Tighten all bell housing bolts to approx. 250 lb.-in. then recheck alignment."
   This step will insure that everything stays put while you take your time applying Loctite and installing 
   bolts for the last time.)

Tools

    If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.

Resources

FAQs (Frequently Asked Questions)