EggGen3: Difference between revisions
From SubeNews
Jump to navigationJump to search
| Line 22: | Line 22: | ||
* [https://wiki.subenews.com/files/Gen3-Gearbox/Gen3-Gearbox-Video.wmv Gen3 Gearbox Video] | * [https://wiki.subenews.com/files/Gen3-Gearbox/Gen3-Gearbox-Video.wmv Gen3 Gearbox Video] | ||
* [[EggGen3:2009H6|Pictures of the 2009 H6 gearbox mounting (should be the same for 2007 and later)]] | * [[EggGen3:2009H6|Pictures of the 2009 H6 gearbox mounting (should be the same for 2007 and later)]] | ||
* [https://wiki.subenews.com/wiki/images/8/88/EggPSRU3v4-diagram.pdf Visio Diagram of Bearings and Seals for Egg PSRU 3v4] ([https://wiki.subenews.com/wiki/images/0/0a/EggPSRU3v4-original-sketch.png original sketch]) | * [https://wiki.subenews.com/wiki/images/8/88/EggPSRU3v4-diagram.pdf Visio Diagram of Bearings and Seals for Egg PSRU 3v4] ([https://wiki.subenews.com/wiki/images/0/0a/EggPSRU3v4-original-sketch.png original sketch])([[File:EggPSRU3v4-diagram.vsd]]) | ||
== FAQs (Frequently Asked Questions) == | == FAQs (Frequently Asked Questions) == | ||
Revision as of 19:33, 11 December 2012
Eggenfellner Gen3 Gearbox
Manufacturer's Listed Specs
Gen3 Howto Guides
- Front Seal Upgrade Procedure Media:FrontSealUpgradeProcedure.pdf
- Gen 3 Gearbox Upgrade Procedure (from previous Generation Gearboxes) Media:G3_Upgrade.pdf
- Quinti Brush Block for G3 Gearbox (Service Bulletin) Media:SB_EarlyQuintiBlock.pdf
- Gen 3 Gearbox Alignment Instructions Media:PropellerGearboxAlignmentProcedure.pdf
(Note: Add the following sentence at the end of step 12 in the Gearbox Alignment Instructions: "Tighten all bell housing bolts to approx. 250 lb.-in. then recheck alignment." This step will insure that everything stays put while you take your time applying Loctite and installing bolts for the last time.)
Tools
If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.
Resources
- Overview of Gearbox Disassembly and Misc Gearbox Pictures
- Gen3 Gearbox Video
- Pictures of the 2009 H6 gearbox mounting (should be the same for 2007 and later)
- Visio Diagram of Bearings and Seals for Egg PSRU 3v4 (original sketch)(File:EggPSRU3v4-diagram.vsd)
