EggGen3: Difference between revisions

From SubeNews
Jump to navigationJump to search
No edit summary
Line 8: Line 8:
* Gen 3 Gearbox Upgrade Procedure (from previous Generation Gearboxes) [[Media:G3_Upgrade.pdf]]
* Gen 3 Gearbox Upgrade Procedure (from previous Generation Gearboxes) [[Media:G3_Upgrade.pdf]]
* Quinti Brush Block for G3 Gearbox (Service Bulletin)  [[Media:SB_EarlyQuintiBlock.pdf]]
* Quinti Brush Block for G3 Gearbox (Service Bulletin)  [[Media:SB_EarlyQuintiBlock.pdf]]
* [[EggGen3:AlignmentTool|Diagrams for making your own Gearbox Alignment Tool]]
    If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.
* Gen 3 Gearbox Alignment Instructions [[Media:PropellerGearboxAlignmentProcedure.pdf]]  
* Gen 3 Gearbox Alignment Instructions [[Media:PropellerGearboxAlignmentProcedure.pdf]]  
     (Note: Add the following sentence at the end of step 12 in the Gearbox Alignment Instructions:
     (Note: Add the following sentence at the end of step 12 in the Gearbox Alignment Instructions:
Line 15: Line 13:
     This step will insure that everything stays put while you take your time applying Loctite and installing  
     This step will insure that everything stays put while you take your time applying Loctite and installing  
     bolts for the last time.)
     bolts for the last time.)
== Tools ==
* [[EggGen3:AlignmentTool|Diagrams for making your own Gearbox Alignment Tool]]
    If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.
== Resources ==
* [[EggGen3:Disassembly|Overview of Gearbox Disassembly and Misc Gearbox Pictures]]
* [[EggGen3:Disassembly|Overview of Gearbox Disassembly and Misc Gearbox Pictures]]
* [https://wiki.subenews.com/files/Gen3-Gearbox/Gen3-Gearbox-Video.wmv Gen3 Gearbox Video]
* [https://wiki.subenews.com/files/Gen3-Gearbox/Gen3-Gearbox-Video.wmv Gen3 Gearbox Video]
* [[EggGen3:2009H6|Pictures of the 2009 H6 gearbox mounting (should be the same for 2007 and later)]]
* [[EggGen3:2009H6|Pictures of the 2009 H6 gearbox mounting (should be the same for 2007 and later)]]


== FAQs (Frequently Asked Questions) ==
== FAQs (Frequently Asked Questions) ==

Revision as of 19:10, 11 December 2012

Eggenfellner Gen3 Gearbox

Manufacturer's Listed Specs

Gen3 Howto Guides

   (Note: Add the following sentence at the end of step 12 in the Gearbox Alignment Instructions:
   "Tighten all bell housing bolts to approx. 250 lb.-in. then recheck alignment."
   This step will insure that everything stays put while you take your time applying Loctite and installing 
   bolts for the last time.)

Tools

    If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.

Resources


FAQs (Frequently Asked Questions)