EggGen3:AlignmentTool: Difference between revisions

From SubeNews
Jump to navigationJump to search
Created page with "* Alignment Bar Media:Alignment-bar.pdf * Pin-10mmx45mm Media:Pin-10mmx45mm.pdf * Pin-12mm Media:Pin-12mm.pdf"
 
No edit summary
 
(3 intermediate revisions by one other user not shown)
Line 1: Line 1:
* Alignment Bar [[Media:Alignment-bar.pdf]]
* Gearbox Alignment Bar [[Media:Alignment-bar.pdf]]
* Gearbox Alignment Plate [[Media:Alignment-plate.pdf]]
* Gearbox Alignment Plate DWG file [[File:Alignment_Plate_(B).dwg]]
* Gearbox Alignment Plate DXF file [[File:Alignment_Plate_(B).dxf]]
* PSRU Alignment Tool DWG file [[File:PSRU_Alignment_Tool_(D).dwg]]
* PSRU Alignment Tool DXF file [[File:PSRU_Alignment_Tool_(D).dxf]]
* Pin-10mmx45mm [[Media:Pin-10mmx45mm.pdf]]
* Pin-10mmx45mm [[Media:Pin-10mmx45mm.pdf]]
* Pin-12mm [[Media:Pin-12mm.pdf]]
* Pin-12mm [[Media:Pin-12mm.pdf]]
* Propellor Gearbox Alignment Procedure [[Media:PropellerGearboxAlignmentProcedure.pdf]]
    If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.

Latest revision as of 02:38, 5 January 2022

    If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.