View source for EggGen3

= Eggenfellner Gen3 Gearbox =

== Manufacturer's Listed Specs ==


== Gen3  Howto Guides ==
* Front Seal Upgrade Procedure [[Media:FrontSealUpgradeProcedure.pdf]]
* Gen 3 Gearbox Upgrade Procedure (from previous Generation Gearboxes) [[Media:G3_Upgrade.pdf]]
* Quinti Brush Block for G3 Gearbox (Service Bulletin)  [[Media:SB_EarlyQuintiBlock.pdf]]
* Gen 3 Gearbox Alignment Instructions [[Media:PropellerGearboxAlignmentProcedure.pdf]] 
    (Note: Add the following sentence at the end of step 12 in the Gearbox Alignment Instructions:
    "Tighten all bell housing bolts to approx. 250 lb.-in. then recheck alignment."
    This step will insure that everything stays put while you take your time applying Loctite and installing 
    bolts for the last time.)
* PSRU Mods by Tom [[Media:2014PSRUMods.pdf]]

== Tools ==
* [[EggGen3:AlignmentTool|Diagrams for making your own Gearbox Alignment Tool]]
     If you make this tool, please use plus/minus .001" as a tolerance between all of the center distances.

== Resources ==
* [[EggGen3:Disassembly|Overview of Gearbox Disassembly and Misc Gearbox Pictures]]
* [https://wiki.subenews.com/files/Gen3-Gearbox/Gen3-Gearbox-Video.wmv Gen3 Gearbox Video]
* [[EggGen3:2009H6|Pictures of the 2009 H6 gearbox mounting (should be the same for 2007 and later)]]
* [[EggGen3:Seal|PSRU Gen 3 v 4 Front Seal Information (ordering details)]]
* Diagram of Bearings and Seals for Egg PSRU 3v4:
** PDF: [[Media:EggPSRU3v4-diagram.pdf]]
** Original Sketch Image: [[Media:EggPSRU3v4-original-sketch.png]]
** [https://wiki.subenews.com/files/Gen3-Gearbox/EggPSRU3v4-diagram.vsd Visio VSD file]

== FAQs (Frequently Asked Questions) ==